The Twin Towers were hit on the morning of September 11, 2001. American Airlines Flight 11 struck the North Tower at 8:46 a.m. Eastern Daylight Time. United Airlines Flight 175 struck the South Tower at 9:03 a.m. The two impacts came 17 minutes apart, each delivered by a Boeing 767 carrying thousands of gallons of jet fuel, and together they set in motion the structural cascade that brought both 110-story towers down within two hours.

That answer fits in a sentence, but the question of when the towers were hit carries a second layer. Timing was not incidental to the outcome. The minute-by-minute sequence of impact times, fuel loads, stairwell integrity, and structural response explains why one tower stood 56 minutes after being struck and the other only 47, why some people above the impact zones survived, and why the collapses followed the pattern they did. This explainer works through that sequence at the level of mechanism, with the timestamps and physical quantities that make the morning legible.

Mechanism: what an impact time actually records

An impact time marks the instant a 767's nose contacted the exterior column line of a tower. Everything that follows flows from the physical state at that moment, not from the clock reading itself. Each aircraft arrived with a specific mass, speed, and fuel load, and each struck a specific elevation and building face. Those variables determined how much structural steel was severed, how much jet fuel was dispersed into occupied floors, and which escape routes were destroyed.

Both flights were Boeing 767-200ER aircraft. Flight 11 carried an estimated 10,000 gallons of jet fuel; Flight 175 carried roughly 9,000 gallons. The aircraft hit at cruising-derived speeds well above normal approach velocity, though the precise figures remain estimates from flight-data and radar reconstruction rather than certified readings. The kinetic energy alone was enormous, but the fire that followed did most of the structural damage.

The towers were built to absorb the impact of a Boeing 707, the largest airliner of the 1960s design era, on a foggy approach. That design case assumed a slower aircraft, lower fuel load, and a pilot attempting to land. The 2001 impacts exceeded every parameter of that case: heavier aircraft, higher speed, full intercontinental fuel loads, and deliberate aim at the middle of the structural system.

Here is the counterintuitive detail. The impact itself did not cause either collapse. The towers swayed, shed cladding, and remained standing. What doomed them was the uncontrolled office fire fed by thousands of gallons of jet fuel, which heated unprotected steel floor trusses and column connections until they lost strength. Impact time set the clock; the fire ran it down.

Plain language: the planes started a fire the buildings could not survive, and the clock started the moment the nose touched steel.

Quantified context: the timeline in numbers

The morning unfolded in a sequence that investigators reconstructed from radar tracks, air-traffic recordings, seismic records, and survivor accounts. The federal investigation that followed, conducted by the National Institute of Standards and Technology, produced the authoritative account of the structural sequence.

Time (EDT) Event Physical significance
8:46:40 Flight 11 strikes North Tower Impact near floors 93-99; all stairwells in the impact zone severed
9:03:11 Flight 175 strikes South Tower Impact near floors 77-85; one stairwell partially survived
9:59:04 South Tower collapses 56 minutes after impact; struck lower, collapsed first
10:28:25 North Tower collapses 102 minutes after impact; struck higher, stood longer

Two numbers in this table deserve attention. First, the South Tower was hit 17 minutes after the North Tower but collapsed 29 minutes before it. The lower impact elevation severed fewer floors above the strike zone but concentrated fire on a smaller, more heavily loaded section of structure. Second, the North Tower stood 102 minutes, more than twice as long as the South Tower's 56 minutes, because its impact zone sat higher, leaving more intact structure below to carry load.

Seismic records from Palisades, New York, and other regional stations registered both collapses as distinct ground-motion events, which gave investigators independent confirmation of the collapse times to within seconds. The timing question is therefore not a matter of recollection; it is instrumented.

Edge cases: why timing varied so much between the towers

The 17-minute gap between impacts is the headline fact, but the more instructive comparison is the 47-minute gap between the two collapse times. Several mechanisms explain it.

Impact elevation mattered most. The South Tower took its strike between floors 77 and 85, roughly 30 floors lower than the North Tower's impact zone. A lower strike meant the fire engaged a section of the building closer to the base, where column loads were greatest and where the surviving structure had less redundancy above to redistribute stress.

Fuel distribution differed. The South Tower's aircraft banked sharply before impact, spreading fuel across multiple floors and igniting a wider fire zone. The North Tower's strike was more axial, concentrating damage along one face. Wider fire spread accelerated the weakening of floor trusses on the South Tower's damaged levels.

Stairwell survival split along the same lines. In the North Tower, every stairwell passing through the impact zone was destroyed, trapping everyone above floor 99. In the South Tower, one stairwell remained passable for a period after impact, which is why a small number of people above the strike zone escaped. The timing of that stairwell's failure is one of the most consequential minutes of the morning, and it is documented in survivor interviews collected by NIST.

The professional caveat: collapse timing is not a clean function of impact time. It depends on the interaction of fire growth, steel temperature, connection behavior, and load redistribution, and NIST modeled these as coupled processes rather than a single countdown. Anyone who reduces the morning to "the towers fell because they were hit" is skipping the mechanism that actually decided the outcome.

Misconceptions: what the timestamps do not mean

Several false or oversimplified claims cluster around the impact times. Each is worth addressing directly.

The collapses were not simultaneous. The South Tower fell at 9:59, the North Tower at 10:28, a 29-minute separation confirmed by seismic and video records. The towers were not designed to survive this scenario. The design case was a slow, low-fuel 707 approach, not a full-speed 767 with intercontinental fuel. The impact did not instantly sever the buildings. Both towers stood for tens of minutes after being struck, which is why thousands escaped from below the impact zones. The collapse times were not determined by the impact times alone. Fire behavior and structural load path governed the interval. No single "melting point" number explains the failure. Structural steel loses strength progressively as it heats, and connection failure occurs well below the melting temperature of steel.

The last point is the one most often garbled. Steel does not need to melt to fail. It needs only to reach a temperature at which its strength drops below the load it carries, and the fire in each tower reached that threshold on the affected floors. The exact temperatures remain modeling estimates, not direct measurements, because the fires destroyed the instrumentation that would have recorded them.

Practical actions: what the timing record supports

The impact and collapse times are not just historical facts. They are the backbone of modern building-safety practice, and the practical lessons are concrete.

Treat evacuation time as a design variable, not an afterthought. The interval between impact and collapse is the evacuation window, and buildings should be designed so that window is as long as possible. Protect stairwell redundancy. The survival of one South Tower stairwell above the impact zone shows that redundant, hardened egress can save lives even in extreme events. Plan for the fire, not just the impact. The towers survived the strike; the fire decided the outcome. Fire suppression, structural fire protection, and fuel-load assumptions belong in the same analysis. Use instrumented timing for forensics. Seismic and video records gave investigators collapse times to the second, and that precision is what made the structural sequence reconstructable. Reconcile design assumptions with realistic threat loads. The 707 design case and the 2001 reality diverged so far that the difference itself became the central finding.

The threshold that matters in practice is not a single number but a relationship: the time available for evacuation must exceed the time it takes for a fire to compromise the load path. When that relationship inverts, as it did in both towers, the outcome is determined by minutes.

Limitations: what the record can and cannot establish

The timing record is unusually well documented, but it has boundaries. Impact times are reconstructed from radar, flight-data, and air-traffic recordings to within seconds, not to the millisecond. Fuel loads are estimates derived from flight plans and aircraft performance, not direct measurements at impact. Fire temperatures and steel behavior are model outputs calibrated against physical evidence, not live readings. Collapse times are the most precise figures, confirmed by seismic instruments and video.

The deeper limitation is that no full-scale test of a 767 impacting a occupied 110-story tower has ever been conducted, and none will be. The understanding of September 11 rests on forensic reconstruction, structural modeling, and survivor evidence, which is a robust but not exhaustive basis. NIST's investigation remains the authoritative public account, and its reports are the primary source for anyone who wants the mechanism at full resolution.

This article is general educational information about a historical event and its engineering context. It is not a safety engineering assessment for any specific building, and it should not be used to evaluate the structural adequacy of any property. Readers with building-safety, evacuation-planning, or structural-engineering questions should consult a qualified local professional.